Detergent Properties and Applications

Biological detergents are commonly used to disrupt the bipolar lipid membrane of cells in order to release and solubilize membrane-bound proteins. Some detergents can be used to solubilize recombinant proteins, while others are recommended for the stabilization, crystallization, or denaturation of proteins. Detergents can align at aqueous/non-aqueous interfaces, resulting in reduced surface tension, increased miscibility, and stabilization of emulsions. Additional detergent applications include:

• Extraction of DNA and RNA
• Solubilization of specimens for diagnostic applications
• Cell lysis
• Liposome preparation
• Prevention of reagent and analyte precipitation from solution
• Prevention of non-specific binding in immunoassays

Detergent Physical Characteristics

The concentration at which micelles begin to form is the critical micelle concentration (CMC). The CMC is the maximum monomer concentration and constitutes a measure of the free energy of micelle formation. The lower the CMC, the more stable the micelle and the more slowly molecules are incorporated into or removed from the micelle. The structure of the hydrophobic region of the detergent can affect the micelle structure. An increase in the length of the hydrophobic hydrocarbon chain of ionic detergents results in an increased micelle size and a lower CMC, as fewer molecules are needed to construct a micelle.

The average number of monomers in a micelle is the aggregation number. The CMC and aggregation number values are highly dependent on factors such as temperature, pH, ionic strength, and detergent homogeneity and purity. Slight discrepancies in reported values for CMC and aggregation number may be the result of variations in the analytical methods used to determine the values. Aggregation number values are also shifted by concentration, since the number of detergent molecules per micelle may increase if the concentration is above the CMC.

Ease of removal or exchange is an important factor in the selection of a detergent. Some of the more common detergent removal methods include:

• Dialysis
• Gel filtration chromatography
• Hydrophobic adsorption chromatography
• Protein precipitation

The CMC value associated with the detergent is a useful guide to hydrophobic binding strength. Detergents with higher CMC values have weaker binding and are subsequently easier to remove by dialysis or displacement methods. Detergents with low CMC values require less detergent in order to form micelles and solubilize proteins or lipids.

Another useful parameter when evaluating detergents for downstream removal is the micelle molecular weight, which indicates relative micelle size. Smaller micelles are more easily removed and are usually desirable when protein-detergent complexes are to be separated based on the molecular size of the protein. The micelle molecular weight may be calculated by multiplying the aggregation number by the monomer molecular weight.

The cloud point is the temperature at which the detergent solution near or above its CMC separates into two phases. The micelles aggregate, typically forming a cloudy phase with high detergent concentration, while the balance of the solution becomes detergent-depleted. The resulting two-phase solution can be separated, with the extracted protein being located in the detergent-rich phase. Detergents with low cloud point temperatures, such as TRITON^® X-114 (cloud point ~23 °C) are recommended for use with proteins since high cloud point temperatures may denature solubilized proteins. The cloud point can be affected by changes in detergent concentration, temperature, and the addition of salt or polymers such as dextran and polyethylene glycol. Note that the detergent-rich phase is also contingent on the specific detergent(s) and salt concentration; under some conditions the phase may be clear rather than cloudy and be located as either the upper or lower phase of the solution. In non-ionic detergents, this behavior has been applied in the phase separation and purification of membrane proteins.²

Detergent Types and Selection

When selecting a detergent, the first consideration is usually the form of the hydrophilic group.

Based on their structure, detergents can be broadly classified as:³

• Ionic
• Zwitterionic
• Non-ionic

Ionic Detergents

Ionic detergents contain anionic or cationic head groups and possess a net charge. Their hydrophobic tails are either straight hydrocarbon chains, as in sodium dodecyl sulfate (SDS) and cetyltrimethylammonium bromide (CTAB ), or rigid steroidal groups, as in bile acid salts.⁴ The size of an ionic detergent micelle is determined by the combined effect of hydrophobic attraction of the side chains and the repulsive forces of the ionic groups. Consequently, neutralizing the charge on the head group with increasing concentrations of a counter ion leads to a larger micellar size. Micellar size also increases with the increase in alkyl chain length. Ionic detergents are extremely effective in the solubilization of membrane proteins but are almost always denaturing to some extent.⁵

Bile acid salts are anionic detergents with backbones consisting of rigid steroidal groups, e.g., sodium salts of cholic acid and deoxycholic acid. Because of their planar structure, these molecules have a polar and a nonpolar face; as a result, their CMC’s are high and their micelles are small, which makes them easy to remove by dialysis.⁶ Bile acids are relatively mild detergents and are often less deactivating than linear-chain detergents with the same head group.⁷ Unconjugated bile acid monomers have pKa values of approximately 5 - 6 and limited solubility at low pH values. However, conjugation of bile acids reduces the pKa and leads to a larger fraction of ionized molecules at any given pH. Since the ionized salt form is more soluble in water than the protonated acid form, conjugation enhances solubility at a low pH.⁸

Non-ionic Detergents

Non-ionic detergents contain uncharged, hydrophilic head groups that consist of either polyoxyethylene moieties, as in BRIJ^® and TRITON™ Detergents, or glycosidic groups, as in octyl glucoside and dodecyl maltoside. Since non-ionic detergents break lipid-lipid and lipid-protein, but not protein-protein interactions, they are considered non-denaturing.⁹ Thus, they are widely used in the isolation of membrane proteins in their biologically active form. Unlike ionic detergents, salts have minimal effect on the micellar size of non-ionic detergents.⁵

Detergents with polyoxyethylene head groups may contain alkylpolyethylene ethers with the general formula CnH2n+1(OCH2CH2)xOH, or a phenyl ring between the alkyl chain and the ether group. TRITON™ X-100 detergent belongs to the latter class. It should be noted that detergents containing aromatic rings absorb in the ultraviolet region. They may interfere with spectrophotometric monitoring of proteins at 280 nm. Hydrogenated versions of these detergents are available, in which the aromatic rings are reduced to eliminate UV absorption. However, small amounts of unreacted material may be present in such reduced preparations. Alternatively, commercially available polyoxyethylene detergents with aliphatic hydrophobic moieties may be substituted for some aromatic polyoxyethylenes in certain applications. For example,

, TERGITOL™ TMN-10, polyoxyethylene 10 lauryl ether, and polyoxyethylene 10 tridecyl ether may be generally substituted for TRITON™ X-100 in applications where UV invisibility is important. These detergents possess aliphatic hydrophobic moieties and therefore do not absorb significantly in the ultraviolet region.

Although polyoxyethylenes have significant cost advantage over synthetic non-ionic detergents such as the alkyl glycosides, the latter remain the detergents of choice in many applications for two main reasons. First, they are homogeneous with respect to their composition and structure. Second, several variations of alkyl glycosides containing different combinations of the hydrocarbon chain and the polar sugar group can be easily synthesized in pure forms. Subtle differences in the physicochemical properties of alkyl glycosides bearing various alkyl chains, attached to a glucose, maltose, or a sucrose head group, can be exploited for selective solubilization of membrane proteins.¹⁰

Zwitterionic Detergents

Zwitterionic detergents have characteristics of both ionic and non-ionic types. Like non-ionic detergents, the zwittergents do not possess a net charge, they lack conductivity and electrophoretic mobility, and do not bind to ion-exchange resins. However, like ionic detergents, they are efficient at breaking protein-protein interactions. Steroid-based zwittergents such as CHAPS are less denaturing than linear-chain zwitterionic detergents (e.g., dodecyldimethyldiamine oxide).⁷

Non-Detergent Sulfobetaines

Non-Detergent Sulfobetaines, NDSBs, are zwitterionic compounds. Like detergent sulfobetaines (SB) – such as linear SBs (e.g., SB 3-16, SB 3-10, 3-12 and 3-14),¹¹ CHAPS¹², and amidosulphobetaines (e.g., N-alkylamidopropyl-N,Ndimethylaminoalkyll- sulphonate)¹³ – NDSBs carry the sulfobetaine hydrophilic head group. However, in contrast to SBs, the hydrophobic groups in NDSBs are too short for micelle formation even at concentrations as high as 1 M. Hence, NDSBs can be easily removed by dialysis and they can readily diffuse in chromatography matrices and polyacrylamide gels for electrophoretic applications.

NDSBs were first employed in native isoelectric focusing experiments to screen electrostatic interactions without increasing the conductivity.¹⁴ Since then, they have found use in a wide range of applications including solubilization and crystallization of proteins^14,15, as well as renaturation and refolding of chemically and thermally denatured proteins.¹⁶ Due to their short hydrophobic groups and chargescreening effect, NDSBs prevent aggregation and result in higher yields of membrane proteins. Furthermore, NDSBs do not interfere with enzymatic assays involving chromogenic substrates bearing nitrophenyl groups and they do not inhibit the activities of enzymes such as β-galactosidase and alkaline phosphatase.¹⁴ It is also noteworthy that NDSB-195, NDSB-211, and NDSB-221 do not absorb at 280 nm; therefore, they are compatible with protein purification procedures in which the protein concentrations are monitored by measuring absorbance at this wavelength.¹⁷

Guidelines for Choosing a Detergent

A membrane protein is considered solubilized if it is present in the supernatant after one hour centrifugation of a lysate or a homogenate at 100,000 x g. In most cases, the biological activity of the protein should be preserved in the supernatant after detergent solubilization. Hence, the appropriate detergent should yield the maximum amount of biologically active protein in the supernatant. Given the large number of detergents available today, choosing an appropriate detergent can be a difficult process. Some of the points outlined below can be helpful in selecting a suitable detergent.

• Survey the literature and try a detergent that has been used previously for the isolation and characterization of a protein with similar biochemical or enzymological properties.
  
• Consider the solubility of the detergent at the working temperature. For example, Dimethylpalmitylammonio) propanesulfonate (SB3-16) is insoluble in water at 4 °C while TRITON™ X-114 Detergent undergoes a phase separation at room temperature.
  
• Consider the method of detergent removal. If dialysis is to be employed, a detergent with a high CMC is clearly preferred. Alternatively, if ion exchange chromatography is utilized, a non-ionic or a zwitterionic detergent is more suitable.
  
• Preservation of biological or enzymological activity may require experimenting with several detergents. Not only the type but also the quantity of the detergent used will affect the protein activity. For some proteins biological activity is preserved over a very narrow range of detergent concentration. Below this range the protein is not solubilized and above a particular concentration, the protein is inactivated.
  
• Consider downstream applications. Since TRITON™ X-100 Detergent contains aromatic rings that absorb at 260-280 nm, this detergent should be avoided if the protocols require UV monitoring of protein concentration. Similarly, ionic detergents should be avoided if the proteins are to be separated by isoelectric focusing. For gel filtration of proteins, detergents with smaller aggregation numbers should be considered.
  
• Consider detergent purity. Detergents of utmost purity should be used since some detergents such as TRITON™ X-100 are generally known to contain peroxides as contaminants.
  
• A variety of Molecular Biology Grade detergents are available for any research where contaminants such as DNase, RNase, and proteases are problematic.
  
• A non-toxic detergent should be preferred over a toxic one. For example, digitonin, a cardiac glycoside, should be handled with special care.
  
• For unknown reasons, specific detergents often work better for particular isolation procedures. For example, n-Dodecyl-β-D-maltoside has been found to be the detergent of choice for the isolation of cytochrome c oxidase. Hence, some “trial and error” may be required for determining optimal conditions for isolation of a membrane protein in its biologically active form.
  
• Sometimes it is difficult to find an optimally suited detergent for both solubilization and analysis of a given protein. In such cases, it is often possible to solubilize proteins with one detergent before replacing it with another that exhibits least interference with analysis.
  
• In some cases, it has been observed that the inclusion of non-detergent sulfobetaines (NDSBs) with detergents in the isolation buffer dramatically improves yields of solubilized membrane proteins.